Conap EasyPoxy Instructions

WARNING - If contents are crystallized upon opening, place in oven at 120° F for 45 to60 minutes.  Remove and allow to cool to room temperature before using.

HANDLING AND CURE INSTRUCTIONS:

1.    Squeeze one equal length bead from each tube on clean,
       dry surface.  Replace caps on proper tubes.

2.    Mix beads together until color is uniform.

3.    The repair surface must be dry and free from oil and dirt.

4.    CURE:    at 77°  F         Hardens in 2 hours    Cures in 24 hours

                        at 140° F       Hardens in 30 min.    Cures in 2 hours

Prevent skin contact with uncured materials.  If contact does occur, rinse with clean denatured alcohol followed by a wash with soap and hot water.

5.    Consult Material Safety Data Sheet for further information.

6.    Storage Temperature 65° F to 85° F.

Conap EasyPoxy is a high performance industrial strength adhesive and should be used by adults only.